Mail Sending
Mail mode has two commands for sending the message you have been
editing:
- C-c C-s
- Send the message, and leave the mail buffer selected (
mail-send).
- C-c C-c
- Send the message, and select some other buffer (
mail-send-and-exit).
C-c C-s (mail-send) sends the message and marks the mail
buffer unmodified, but leaves that buffer selected so that you can
modify the message (perhaps with new recipients) and send it again.
C-c C-c (mail-send-and-exit) sends and then deletes the
window or switches to another buffer. It puts the mail buffer at the
lowest priority for reselection by default, since you are finished with
using it. This is the usual way to send the message.
In a file-visiting buffer, sending the message does not clear the
modified flag, because only saving the file should do that. As a
result, you don't get a warning if you try to send the same message
twice.
When you send a message that contains non-ASCII characters, they need
to be encoded with a coding system (see Coding Systems). Usually
the coding system is specified automatically by your chosen language
environment (see Language Environments). You can explicitly specify
the coding system for outgoing mail by setting the variable
sendmail-coding-system (see Recognize Coding).
If the coding system thus determined does not handle the characters in
a particular message, Emacs asks you to select the coding system to use,
showing a list of possible coding systems.
|
